Toyota Celica 2005 Repair Manual page 2351

Adhesive
5.0 mm
(0.197 in.)
Adhesive
Primer M
2005 CELICA (RM1131U)
4.
(a)
HINT:
After cutting off the tip, use all adhesive within the time de-
scribed in the table below.
A
(b)
(c)
5.0 mm
(0.197 in.) HINT:
When removing the moulding, apply adhesive well to the part
where the body sealer is removed.
H10546
5.
Push the moulding to the body.
NOTICE:
S
S
S
S
BODY − ROOF SIDE MOULDING
APPLY ADHESIVE
Cut off the tip of the cartridge nozzle.
Part No. 08850−00801 or equivalent
Temperature
35°C (95°F)
20°C (68°F)
5°C (41°F)
Load the cartridge into the sealer gun.
Apply adhesive to the hatched area in the illustration for
both front and rear of the vehicle.
Front and rear end:
A: 50 mm (1.97 in.)
INSTALL MOULDING
Make sure that the body and moulding are heated to
the proper temperature.
Do not depress the adhesive coated parts excessive-
ly but just hold them down with your thumb.
Scrape off any overflowing adhesive with a plastic
spatula and clean the surface with a dry rag.
Take care not to drive the vehicle during the time de-
scribed in the table below.
Temperature
35°C (95°F)
20°C (68°F)
5°C (41°F)
2350
Tackfree time
15 minutes
100 minutes
8 hours
Minimum time prior to driving the vehicle
1.5 hours
5 hours
24 hours
BO−45