Toyota Celica 2005 Repair Manual page 1736

MX−18
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
17.
x 5
Remove the 5 bolts and rear bearing retainer.
18.
Using a snap ring expander, remove the 2 snap rings.
HINT:
Q05785
If it is difficult to remove and install the snap rings, pull up the
shafts.
19.
20.
Using 2 screwdrivers and a hammer, tap out the snap ring.
Q05786
21.
(a)
(b)
Q07842
22.
Using a hexagon wrench, remove the lock ball assembly.
Q07843
− MANUAL TRANSAXLE ASSEMBLY
REMOVE REAR BEARING RETAINER
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 27 N·m (280 kgf·cm, 20 ft·lbf)
REMOVE BEARING SNAP RING
REMOVE REVERSE IDLER GEAR SHAFT LOCK BOLT
AND GASKET
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
REMOVE SNAP RING FROM NO. 2 SHIFT FORK
SHAFT
REMOVE STRAIGHT SCREW PLUG, SEAT, SPRING
AND BALL
Using a hexagon wrench, remove the 3 straight screw
plugs.
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
Using a magnetic finger, remove the 3 seats, springs and
balls.
REMOVE LOCK BALL ASSEMBLY
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
1735