Toyota Celica 2005 Repair Manual page 2132

SUPPLEMENTAL RESTRAINT SYSTEM
SST
Battery
SST
10 m (33 ft) or more
2005 CELICA (RM1131U)
− FRONT PASSENGER AIRBAG ASSEMBLY
(b) Disconnect the airbag connector.
(1) Using a screwdriver, pry out the glove compartment
door finish plate inside the lower panel.
HINT:
Tape the screwdriver tip before use.
(2) Remove the connector from the glove compartment
door finish plate.
NOTICE:
When handling the airbag connector, take care not to dam-
H12009
age the airbag wire harness.
(3) Disconnect the airbag connector.
(c) Install the SST.
(1) Connect the connectors of the 2 SST to the front
passenger airbag assembly connector.
SST 09082−00700, 09082−00760
NOTICE:
To avoid damaging the SST connector and wire harness,
do not lock the secondary lock of the twin lock.
H11960
(2) Move the SST to at least 10 m (33 ft) away from the
front of the vehicle.
(3) Close all the doors and windows of the vehicle.
NOTICE:
Take care not to damage the SST wire harness.
(4) Connect the SST red clip to the battery positive (+)
terminal and the black clip to the negative (−) termi-
nal.
R13455
(d) Deploy the airbag.
(1) Check that no one is inside the vehicle or within 10
m (33 ft) area around the vehicle.
(2) Press the SST activation switch and deploy the air-
bag.
H03286
2131
RS−31