Toyota Celica 2005 Repair Manual page 1697

CH−14
Pulley
29 mm
Socket
Wrench
B
Wire Clip
A
SST (B)
2005 CELICA (RM1131U)
CHARGING
REASSEMBLY
1.
(a)
(b)
B00219
2.
(a)
B00239
(b)
B00211
(c)
A
A
B07735
3.
(a)
Turn
(b)
SST(A)
(c)
B00210
− GENERATOR
INSTALL ROTOR TO DRIVE END FRAME
Place the drive end frame on the pulley.
Install the rotor to the drive end frame.
INSTALL RECTIFIER END FRAME
Place the generator washer on the rotor.
Using a 29 mm socket wrench and press, slowly press in
the rectifier end frame.
Install the wire clip and 4 nuts.
Torque:
Nut A 4.5 N·m (46 kgf·cm, 40 in.·lbf)
Nut B 5.4 N·m (55 kgf·cm, 48 in.·lbf)
INSTALL PULLEY
Install the pulley to the rotor shaft by tightening the pulley
nut by hand.
Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST 09820−63011
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Check that SST (A) is secured to the pulley shaft.
1696
CH0CB−10