Toyota Celica 2005 Repair Manual page 1792

2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
20.
(a)
HINT:
At the time of reassembly, please refer to the following item.
Select a snap ring from the table below that will make the thrust
clearance of the No. 3 clutch hub less than 0.1 mm (0.0039 in.).
D06032
Mark
(b)
SST
D08256
HINT:
At the time of reassembly, please refer to the following items.
S
Wooden
Block
D00469
S
NOTICE:
S
SST
Press
S
D00303
− MANUAL TRANSAXLE ASSEMBLY
REMOVE 5TH GEAR, NO. 3 SYNCHRONIZER RING
(FOR 5TH GEAR) AND NO. 3 CLUTCH HUB AS-
SEMBLY
Using 2 screwdrivers and a hammer, tap out the snap
ring.
Thickness mm (in.)
A 1.75 (0.0689)
B 1.80 (0.0709)
C 1.85 (0.0728)
D 1.90 (0.0748)
E 1.95 (0.0768)
Using SST, remove the No. 3 clutch hub assembly.
SST 09950−30012 (09951−03010, 09953−03010),
09950−50013 (09954−05031)
Before driving in the No. 3 clutch hub assembly and input
shaft rear radial ball bearing, place the suitable sized
wooden block on the rear side of the input shaft, as shown
in the illustration. When driving them in, fix the input shaft
firmly so that it is not pushed downward. Otherwise the in-
put shaft center bearing is overloaded, it might be dam-
aged.
Using SST and a hammer, drive in the No. 3 clutch hub
assembly.
SST 09612−22011
Align the No. 3 synchronizer ring slots with the No. 3
shifting keys.
Be sure to install the No. 3 clutch hub assembly in the
correct direction, as shown in the illustration.
1791
Mark Thickness mm (in.)
F 2.00 (0.0787)
G 2.05 (0.0807)
H 2.10 (0.0827)
J 2.15 (0.0846)
− −
MX−19