Toyota Celica 2005 Repair Manual page 2097

Rack Groove
SST
Brass Bar
2005 CELICA (RM1131U)
STEERING −
11. INSTALL RH AND LH CLAW WASHERS AND RACK
ENDS
(a) Install a new claw washer, and temporarily install the rack
end.
HINT:
Align the claws of the claw washer with the steering rack
grooves.
F09894
(b) Using a spanner, hold the steering rack steadily and using
SST, torque the rack end.
SST
Torque: 62 N·m (630 kgf·cm, 46 ft·lbf)
Fulcrum
NOTICE:
Length
Use SST 09922−10010 in the direction shown in the illustra-
tion.
HINT:
Use a torque wrench with a fulcrum length of 380 mm (14.96
F09895
in.).
(c) Using a brass bar and a hammer, stake the washer.
NOTICE:
Avoid any impact on the steering rack.
(d) Employ the same manner described above to the other
side.
F09896
12. INSTALL RH AND LH RACK BOOTS, WIRES AND
CLIPS
(a) Ensure that the steering rack hole is not clogged with
grease.
HINT:
If the hole is clogged, the pressure inside the boot will change
after it is assembled and the steering wheel is turned.
(b) Install the boot, clip and a new wire.
NOTICE:
F09897
Be careful not to damage or twist the boot.
(c) After winding and tightening the wire around the circum-
ference of the boot twice, twist it several times, and install
it.
F09924
2096
POWER STEERING GEAR
09922−10010
SR−51