Toyota Celica 2005 Repair Manual page 1758

MX−40
C
B
A
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
3.
Using a feeler gauge, measure the clearance between the re-
verse gear and gear shift fork.
If the clearance exceeds the maximum, replace the gear shift
fork or hub sleeve.
WM0066
4.
(a)
(b)
If the outer diameter is less than the minimum, replace the out-
MT0071
put shaft.
(c)
If the runout exceeds the maximum, replace the output shaft.
CM0015
− OUTPUT SHAFT
INSPECT GEAR SHIFT FORK AND REVERSE GEAR
CLEARANCE
Maximum clearance: 0.35 mm (0.014 in.)
INSPECT OUTPUT SHAFT
Check the output shaft for wear or damage.
Using a micrometer, measure the outer diameter of the
output shaft journal surface.
Minimum outer diameter:
Part A: 32.985 mm (1.2986 in.)
Part B: 37.985 mm (1.4955 in.)
Part C: 31.985 mm (1.2592 in.)
Using a dial indicator, check the shaft runout.
Maximum runout: 0.03 mm (0.0012 in.)
1757