Toyota Celica 2005 Repair Manual page 1582

E
F
Air
E
F
2005 CELICA (RM1131U)
Ohmmeter
Continuity
B09584
Ohmmeter
No Continuity
B09585
Air
B09586
Battery
B09587
SFI − VSV FOR EVAPORATIVE EMISSION (EVAP)
INSPECTION
1. REMOVE VSV
(a) Disconnect the 2 EVAP hoses from the VSV.
(b) Disconnect the VSV connector.
(c) Remove the bolt and VSV.
2. INSPECT VSV FOR OPEN CIRCUIT
Using an ohmmeter, check that there is continuity between the
terminals.
Resistance: 27 − 33 Ω at 20°C (68°F)
If there is no continuity, replace the VSV.
3. INSPECT VSV FOR GROUND
Using an ohmmeter, check that there is no continuity between
each terminal and the body.
If there is continuity, replace the VSV.
4. INSPECT VSV OPERATION
(a) Check that air flows with difficulty from port E to port F.
(b) Apply battery voltage across the terminals.
(c) Check that air flows from port E to port F.
If operation is not as specified, replace the VSV.
5. REINSTALL VSV
(a) Install the VSV with the bolt.
(b) Connect the VSV with the bolt.
(c) Connect the 2 EVAP hoses to the VSV.
1581
SF−61
SF15X−10