Toyota Celica 2005 Repair Manual page 2069

Torx® Screw
2005 CELICA (RM1131U)
STEERING
14.
(a)
(b)
(c)
HINT:
The cable will rotate about 2.5 turns to either left or right of the
Marks
center.
F08843
15.
(a)
(b)
(c)
16.
NOTICE:
S
S
S
S
(a)
(b)
Screw Case
(c)
17.
F08841
− TILT STEERING COLUMN
CENTER SPIRAL CABLE
Check that the front wheels are facing straight ahead.
Turn the cable counterclockwise by hand until it becomes
harder to turn.
Then rotate the cable clockwise about 2.5 turns to align
the marks.
INSTALL STEERING WHEEL
Align the matchmarks on the steering wheel and main
shaft assembly.
Install the steering wheel set nut.
Torque: 50 N·m (510 kgf·cm, 37 ft·lbf)
Connect the connector.
INSTALL STEERING WHEEL PAD
Never use airbag parts from another vehicle. When
replacing parts, replace with new ones.
Make sure the wheel pad is installed with the speci-
fied torque.
If the wheel pad has been dropped, or there are
cracks, dents or other defects in the case or connec-
tor, replace the wheel pad with a new one.
When installing the wheel pad, take care that the wir-
ings do not interfere with other parts and that they are
not pinched between other parts.
Connect the airbag connector.
Install the steering wheel pad after confirming that the cir-
cumference groove of the torx® screws is caught on the
screw case.
Using a torx® socket wrench, torque the 2 screws.
Torque: 8.8 N·m (90 kgf·cm, 78 in.·lbf)
CHECK STEERING WHEEL CENTER POINT
2068
SR−23