Toyota Celica 2005 Repair Manual page 1737

2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
23.
(a)
(b)
Z00668
HINT:
FIPG
At the time of reassembly, please refer to the following item.
Apply FIPG to the transaxle case, as shown in the illustration.
D07333
24.
Remove the 2 bolts and oil receiver pipes from the transmission
case.
NOTICE:
At the time of reassembly, please refer to the following
items.
S
S
D07351
25.
26.
Remove the 2 bolts and reverse shift arm bracket.
NOTICE:
At the time of reassembly, please refer to the following
items.
S
Q08151
S
− MANUAL TRANSAXLE ASSEMBLY
REMOVE TRANSMISSION CASE
Remove the 16 bolts.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
Using a plastic hammer, carefully tap the projection of the
transmission case to remove the transmission case from
the transaxle case.
FIPG:
Part No. 08826−00090, THREE BOND 1281 or equiva-
lent
REMOVE OIL RECEIVER PIPE
Torque: 17 N·m (175 kgf·cm, 13 ft·lbf)
Prevent the oil receiver pipes from being deformed.
Install the oil receiver pipes while placing it against
the transmission case, as shown in the illustration.
REMOVE REVERSE IDLER GEAR, THRUST WASHER
AND SHAFT
REMOVE REVERSE SHIFT ARM BRACKET
Torque: 17 N·m (175 kgf·cm, 13 ft·lbf)
Set the pin on the top of the reverse shift arm into a
groove on the reverse idler gear.
Fit the claw of the reverse shift arm bracket with the
notch of the input shaft front bearing.
1736
MX−19