Toyota Celica 2005 Repair Manual page 1718

CL−18
SST
5
SST
3
6
2
SST
2005 CELICA (RM1131U)
Flywheel Side
D07710
1
4
Matchmarks
D00204
D00205
Q05807
CLUTCH − CLUTCH UNIT
INSTALLATION
1. INSTALL CLUTCH DISC AND CLUTCH COVER ON
FLYWHEEL
(a) Insert SST in the clutch disc, then insert them in the fly-
wheel.
SST 09301−00210
HINT:
Take care not to insert clutch disc in the wrong direction.
(b) Align the matchmarks on the clutch cover and flywheel.
(c) Following the procedures shown in the illustration, tighten
the 6 bolts in the order starting the bolt locating near the
knock pin on the top.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
HINT:
Following the order in the illustration, tighten the bolts at
S
a time evenly.
Move SST up and down, right and left lightly, after check-
S
ing that the disc is in the center, tighten the bolts.
2. CHECK DIAPHRAGM SPRING TIP ALIGNMENT
Using a dial indicator with roller instrument, check the dia-
phragm spring tip alignment.
Maximum non−alignment: 0.5 mm (0.020 in.)
If alignment is not as specified, using SST, adjust the dia-
phragm spring tip alignment.
SST 09333−00013
3. INSTALL BOOT AND RELEASE FORK SUPPORT TO
TRANSAXLE
Torque: 37 N·m (375 kgf·cm, 27 ft·lbf)
4. APPLY RELEASE HUB GREASE
Apply release hub grease to the release fork and hub contact,
release fork and push rod contact and release fork pivot points.
Sealant:
Part No. 08887−01806, RELEASE HUB GREASE or
equivalent
5. APPLY CLUTCH SPRING GREASE
Apply clutch spline grease to the input shaft spline.
Sealant:
Part No. 08887−01706, CLUTCH SPLINE GREASE or
equivalent
6. INSTALL RELEASE BEARING AND FORK TO TRANS-
AXLE
Install the bearing to the release fork, and then install them to
the transaxle.
7. INSTALL TRANSAXLE TO ENGINE
(C56: See page MX−9)
(C60: See page MX−9)
1717
CL032−14