Toyota Celica 2005 Repair Manual page 1765

2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
DISASSEMBLY
1.
Matchmarks (a)
(b)
(c)
D00855
2.
(a)
SST
HINT:
Set the claw of SST to the bearing inner race securely.
(b)
D08248
3.
SST
Using SST, remove the tapered roller bearing.
HINT:
Set the claw of SST to the bearing inner race at the position
where the differential case is indented.
D07367
4.
Using a dial indicator, measure the backlash of one side gear
while holding one pinion toward the differential case.
If the backlash is not within the specification, install the correct
thrust washer to the side gears.
5.
(a)
Q00807
(b)
(c)
− DIFFERENTIAL CASE
REMOVE RING GEAR
Place matchmarks on the ring gear and differential case.
Remove the 8 bolts.
Using a copper hammer, tap on the ring gear to remove
it from the differential case.
Vehicle speed sensor drive gear side:
REMOVE TAPERED ROLLER BEARING FROM DIF-
FERENTIAL CASE
Using SST, remove the tapered roller bearing.
SST 09950−00020, 09950−00030, 09950−40011
(09957−04010), 09950−60010 (09951−00350)
Remove the vehicle speed sensor drive gear.
Ring gear side:
REMOVE TAPERED ROLLER BEARING FROM DIF-
FERENTIAL CASE
SST 09950−40011, 09950−60010 (09951−00350)
INSPECT SIDE GEAR BACKLASH
Standard backlash:
0.05 − 0.20 mm (0.0020 − 0.0079 in.)
DISASSEMBLE DIFFERENTIAL CASE
Using a pin punch and hammer, drive out the straight pin.
Remove the pinion shaft from the differential case.
Remove the 2 pinions and side gears with the 4 thrust
washers from each gear.
1764
MX−47
MX09T−04