Toyota Celica 2005 Repair Manual page 2318

BO−12
4 Clips
2005 CELICA (RM1131U)
BODY − FRONT DOOR
5. REMOVE DOOR TRIM
(a) Using a screwdriver, remove the 2 plug hole covers.
HINT:
Tape the screwdriver tip before use.
(b) Remove the 6 screws.
(c) Insert a screwdriver between the door panel and door trim
to pry the trim out.
HINT:
Tape the screwdriver tip before use.
H12228
(d) Pull the trim upward to remove it, then disconnect the
locking cable and open cable from the door inside handle.
HINT:
At the time of reassembly, please refer to the following
S
items.
Check that a ball at the end of the locking cable is
S
pressed. (The cable should be locked.)
Turn the locking knob of the inside handle fully to the lock
S
side and install the locking cable.
H12229
(e) Remove the screw and door inside handle from the door
trim.
(f) Using a screwdriver, remove the front door inner weather-
strip from the door trim.
6. REMOVE DOOR SIDE AIRBAG SENSOR
NOTICE:
If the wiring connector of the SRS is disconnected
S
with the ignition switch in ON or ACC position, DTCs
will be recorded.
Never use SRS parts removed from another vehicle.
S
When replacing parts, replace them with new ones.
Never reuse the sensor involved in a collision where
S
the SRS has deployed.
Never repair a sensor in order to reuse it.
S
Disconnect the connector, then remove the 2 bolts and door
side airbag sensor.
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
NOTICE:
At the time of reassembly, please refer to the follow-
S
ing items.
Make sure the sensor is installed in the specified
S
torque.
If the sensor has been dropped, or there are cracks,
S
dents or any other defects are identified in the case,
brackets or connector, replace the sensor. Always re-
place the set bolts with new ones.
The sensor set bolts have been anti−rust treated.
S
When the sensor is removed, always replace the set
bolts with new ones.
After installation, shake the sensor to check that
S
there is no looseness.
2317