Toyota Celica 2005 Repair Manual page 2134

SUPPLEMENTAL RESTRAINT SYSTEM
Stripped Wire Harness Section
2005 CELICA (RM1131U)
(b)
Wire Harness
Diameter
CAUTION:
If the front passenger airbag assembly is tied down with
too thin wire harness, it may snap. This is highly danger-
ous. Always use a wire harness which is at least 1.25 mm
(0.0019 in
AB0163
HINT:
To calculate the square of the stripped wire harness section:
H11961
H11962
Width
Inner
diam.
H11963
− FRONT PASSENGER AIRBAG ASSEMBLY
Using a service−purpose wire harness, tie down the front
passenger airbag assembly to the tire.
Wire harness: Stripped wire harness section
2
1.25 mm or more (0.0019 in.
2
.).
Square = 3.14 X (Diameter)
(1) Install the 2 nuts on the front passenger airbag as-
sembly.
(2) Wind the wire harness around the bolts, and pass
the wire harness though the installation holes.
(3) Position the front passenger airbag assembly in-
side the tire with the airbag deployment side facing
inside.
Tire size: Must exceed the following dimensions−
Width: 185 mm (7.28 in.)
Inner diameter: 360 mm (14.17 in.)
2133
2
or more)
2
divided by 4
RS−33
2