Toyota Celica 2005 Repair Manual page 2321

2005 CELICA (RM1131U)
BODY − FRONT DOOR
15. w/ Power window:
If replacing the window regulator:
REMOVE WINDOW REGULATOR FROM MOTOR
(a) Remove the 2 screws and cover plate.
(b) Using needle nose pliers, remove the drum and wire
guide from the motor.
NOTICE:
Do not use a screwdriver etc. to remove them.
H06190
16. REMOVE SPEAKER
(a) Using a rivet cutter and drill, drill out the rivets and remove
the speaker.
HINT:
Even if flanges are taken off, continue drilling and push out re-
maining flangments with the drill.
(b) Disconnect the connector.
(c) Using a vacuum cleaner, remove the drilled rivets and the
associated metallic dust from the inside of the door panel.
H12164
CAUTION:
Do not touch the cut rivets and rivet cutter as they will be
not.
NOTICE:
Do not jiggle the rivet cutter while cutting.
S
Otherwise you may enlarge the rivet hole or damage
S
the rivet cutter.
HINT:
Do not drill the door inner hole.
HINT:
At the time of reassembly, please refer to the following item.
Using an air riveter, strike rivets into the door panel to install the
speaker to the door panel.
H12230
NOTICE:
At the time of reassembly, please refer to the following
item.
If the rivets are not positioned perpendicular to the as-
sembled surface the mandrel will be bent. If the trigger is
pulled in this condition, the air riveter may be also dam-
aged.
H00475
2320
BO−15