Toyota Celica 2005 Repair Manual page 2021

BR−34
F09542
F09543
2005 CELICA (RM1131U)
BRAKE − REAR BRAKE PAD
REPLACEMENT
1. REMOVE REAR WHEEL
2. INSPECT PAD LINING THICKNESS
Check the pad thickness.
Minimum thickness: 1.0 mm (0.039 in.)
F09541
3. REMOVE CLIP, 2 ANTI−RATTLE SPRINGS AND 2 PAD
GUIDE PINS
(a) Using a screwdriver, remove the clip and 2 anti−rattle
springs.
NOTICE:
Do not deform the clip and anti−rattle spring.
S
The clip and anti−rattle spring can be used again pro-
S
vided that they have sufficient rebound, no deforma-
tion, cracks or wear, and have had all rust, dirt and for-
eign particles cleaned off.
(b) Remove the 2 pad guide pins.
4. REMOVE PADS AND ANTI−SQUEAL SHIMS
(a) Remove the 2 pads.
(b) Remove the anti−squeal shim from each pad.
5. CHECK DISC THICKNESS AND RUNOUT (See page
BR−39)
6. INSTALL NEW PADS
NOTICE:
When replacing worn pads, the anti−squeal shims must be
F09783
replaced together with the pads.
(a) Apply disc brake grease to inside of anti−squeal shims
(See page BR−33).
(b) Install the anti−squeal shim on each pad.
(c) Draw out a small amount of brake fluid from the reservoir.
(d) Press in the piston with a hammer handle or equivalent.
HINT:
Tape the hammer handle before use.
S
If the piston is difficult to push in, loosen the bleeder plug
S
and push in the piston while letting some brake fluid es-
cape.
(e) Install the two brake pads with the anti−squeal shims to
the brake caliper.
F09544
(f) Install the two guide pins to fix the brake pads.
2020
BR14C−03