Toyota Celica 2005 Repair Manual page 1742

MX−24
Plastic Hammer
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
(e)
SST
NOTICE:
S
S
D00325
(f)
6.
Install the transaxle case receiver to the transaxle case with the
bolt.
7.
(a)
(b)
Q07850
(c)
(d)
(e)
(f)
Z00707
8.
(a)
Extension Bar
NOTICE:
Socket Wrench
When driving out the bushing, be careful not to damage the
transmission case by the socket wrench.
D07349
− MANUAL TRANSAXLE ASSEMBLY
Using SST and a press, install a new output shaft front
bearing.
SST 09950−60010 (09951−00560), 09950−70010
(09951−07150)
Be sure to install a new bearing in the correct direc-
tion, as shown in the illustration.
When replacing the output shaft front bearing, re-
place the output shaft front bearing inner race along
with it.
Install the bearing lock plate with the bolt.
Torque: 11 N·m (115 kgf·cm, 8 ft·lbf)
INSTALL TRANSAXLE CASE RECEIVER
Torque: 11 N·m (115 kgf·cm, 8 ft·lbf)
IF NECESSARY, REPLACE REVERSE RESTRICT PIN
Using a hexagon wrench, remove the straight screw plug.
Using a pin punch and hammer, drive out the slotted
spring pin.
Replace the reverse restrict pin.
Using a pin punch and hammer, drive in the slotted spring
pin.
Apply sealant to the screw plug threads.
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Using a hexagon wrench, install the straight screw plug.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
IF NECESSARY, REPLACE TRANSMISSION CASE
BUSHING
Using a socket wrench (12 mm), extension bar and plastic
hammer, drive out the bushing.
1741