SR−20
2005 CELICA (RM1131U)
STEERING
F08878
F08879
Extension Bar
F08873
F08487
−
TILT STEERING COLUMN
(d)
Install the No. 1 support reinforce with the No. 2 tilt lever
lock bolt by turning it counterclockwise.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
HINT:
Align the No. 1 support reinforce with the nut to eliminate loose-
ness by turning the No. 1 support reinforce counterclockwise a
little, then torque the No. 2 tilt lever lock bolt.
(e)
Install the tilt spring.
5.
INSTALL 2 NO. 1 SUPPORT COLLARS AND BRACK-
ET SPACER
(a)
Install 2 new No. 1 support collars.
HINT:
Install the white support collar to the RH side, black support col-
lar to the LH side.
(b)
Using an extension bar and a hammer, drive in the brack-
et spacer.
6.
INSTALL TILT STEERING SUPPORT
Install the tilt steering support with the bolt.
Torque: 15 N·m (155 kgf·cm, 11 ft·lbf)
NOTICE:
Make sure that the tilt steering support is installed facing
in the correct direction.
7.
INSTALL COLUMN UPPER BRACKET AND COLUMN
UPPER CLAMP
(a)
Install the column upper bracket and column upper clamp
with 2 new tapered−head bolts.
(b)
Tighten the 2 tapered−head bolts until the bolt heads
break off.
2065