Toyota Celica 2005 Repair Manual page 1619

CO−18
Dimension "B"
SST
Claw
Overhaul Handle
SST
Stopper Bolt
2005 CELICA (RM1131U)
COOLING
DISASSEMBLY
1.
(a)
(b)
2.
Part "A"
(a)
Stopper Bolt
(b)
NOTICE:
CO1205
If this adjustment is not done the claw may be damaged.
3.
Tank
Using SST to release the caulking, squeeze the handle until
stopped by the stopper bolts.
Lock
Plate
B08773
4.
Lightly tap the bracket of the radiator (or radiator inlet or outlet)
with a soft−faced hammer, and remove the tank and the O−ring.
Tap
B08774
5.
(a)
(b)
(c)
B08775
− RADIATOR
REMOVE DRAIN PLUG
Remove the drain plug.
Remove the O−ring.
DENSO Made:
ASSEMBLE SST
SST 09230−01010
Install the claw to the overhaul handle, inserting it in the
hole in part "A" as shown in the diagram.
While gripping the handle, adjust the stopper bolts so that
dimension "B" shown in the diagram is 0.2 − 0.3 mm
(0.008 − 0.012 in.).
DENSO Made:
UNCAULK LOCK PLATES
SST 09230−01010
DENSO Made:
REMOVE TANKS AND O−RINGS
A/T (DENSO Made):
REMOVE OIL COOLER FROM LOWER TANK
Loosen the nut, and remove the cooler pipe.
Remove the 2 nuts and 2 plate washers.
Remove the oil cooler and 2 O−rings.
1618
CO04R−10