Toyota Celica 2005 Repair Manual page 1691

CH−8
SST (B)
SST (C)
2005 CELICA (RM1131U)
CHARGING
DISASSEMBLY
Plate Terminal
1.
(a)
(b)
B07732
2.
(a)
(b)
(c)
B07733
3.
(a)
(b)
B07734
4.
(a)
Turn
SST (A)
(b)
B00210
(c)
(d)
SST (B)
Insert
B00224
− GENERATOR
REMOVE REAR END COVER
Remove the nut and terminal insulator.
Remove the bolt, 3 nuts, plate terminal and end cover.
REMOVE BRUSH HOLDER AND VOLTAGE REGULA-
TOR
Remove the brush holder cover from the brush holder.
Remove the 5 screws, brush holder and voltage regulator.
Remove the seal plate from the rectifier end frame.
REMOVE RECTIFIER HOLDER
Remove the 4 screws and rectifier holder.
Remove the 4 rubber insulators.
REMOVE PULLEY
Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST 09820−63011
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Check that SST (A) is secured to the rotor shaft.
Mount SST (C) in a vise.
Insert SST (B) into SST (C), and attach the pulley nut to
SST (C).
1690
CH025−09