Toyota Celica 2005 Repair Manual page 1481

1ZZ−FE:
2ZZ−GE:
A01202
2005 CELICA (RM1131U)
ENGINE MECHANICAL
HINT:
If replacing a bearing, replace it with one having the same num-
ber as marked on the connecting rod. There are 3 sizes of stan-
Mark
dard bearings, marked "1", "2" and "3" accordingly.
1, 2 or 3
Reference
Standard bearing center wall thickness
1ZZ−FE:
Mark
1, 2 or 3
A01198
2ZZ−GE:
(j) Completely remove the Plastigage.
21. REMOVE PISTON AND CONNECTING ROD
ASSEMBLIES
(a) Using a ridge reamer, remove all the carbon from the top
of the cylinder.
(b) Push the piston, connecting rod assembly and upper
bearing through the top of the cylinder block.
HINT:
Keep the bearings, connecting rod and cap together.
S
Arrange the piston and connecting rod assemblies in the
S
A01166
correct order.
22. REMOVE BEARING CAP SUB−ASSEMBLY AND
CRANKSHAFT REAR OIL SEAL, AND CHECK OIL
CLEARANCE
(a) 2ZZ−GE:
Remove the 4 screw plugs from the bearing cap sub−as-
sembly.
(b) Remove the 10 hexagon head bearing cap sub−assem-
bly bolts.
(c) Uniformly loosen and remove the 10 bearing cap sub−as-
sembly bolts, in several passes, in the sequence shown.
A10363
− CYLINDER BLOCK
Mark
"1"
"2"
"3"
Mark
"1"
"2"
"3"
1480
1.486 − 1.490 (0.0585 − 0.0587)
1.490 − 1.494 (0.0587 − 0.0588)
1.494 − 1.498 (0.0588 − 0.0590)
1.482 − 1.486 (0.0583 − 0.0585)
1.486 − 1.490 (0.0585 − 0.0587)
1.490 − 1.494 (0.0587 − 0.0588)
EM−95
mm (in.)
mm (in.)