Toyota Celica 2005 Repair Manual page 1675

Ohmmeter
No Continuity
Lock
Terminal 50
Terminal C
Continuity
Terminal 50
Switch Body
2005 CELICA (RM1131U)
STARTING
B00216
Free
ST0950
Ohmmeter
Continuity
B00228
Ohmmeter
B00227
− STARTER
11. INSPECT BRUSH HOLDER INSULATION
Using an ohmmeter, check that there is no continuity between
the positive (+) and negative (−) brush holders.
If there is continuity, repair or replace the brush holder.
12. INSPECT GEAR TEETH
Check the gear teeth on the pinion gear, idler gear and clutch
assembly for wear or damage.
If damaged, replace the gear or clutch assembly.
If damaged, also check the drive plate ring gear for wear or
damage.
13. INSPECT CLUTCH
Rotate the clutch pinion gear clockwise, and check that it turns
freely.
Try to rotate the clutch pinion gear counter−clockwise and
check that it locks.
If necessary, replace the clutch assembly.
14. DO MAGNETIC SWITCH PULL−IN COIL OPEN
CIRCUIT TEST
Using an ohmmeter, check that there is continuity between ter-
minals 50 and C.
If there is no continuity, check and replace the magnetic switch.
15. DO MAGNETIC SWITCH HOLD−IN COIL OPEN
CIRCUIT TEST
Using an ohmmeter, check that there is continuity between ter-
minal 50 and the switch body.
If there is no continuity, replace the magnetic switch.
1674
ST−9