Toyota Celica 2005 Repair Manual page 2099

Matchmarks
E
C
Nut
D
2005 CELICA (RM1131U)
STEERING
INSTALLATION
1.
(a)
(b)
2.
(a)
(b)
(c)
F08865
3.
Install the front suspension member with lower suspension arm
and PS gear assembly with the 6 bolts (bolt C, D and E).
B
4.
A
Connect the engine front mount insulator and front suspension
member with the 2 bolts (bolt B).
C
5.
Connect the engine rear mount insulator and front suspension
D
member with the bolt (bolt A) and 3 nuts.
6.
F08864
(a)
(b)
7.
− POWER STEERING GEAR
INSTALL ENGINE REAR MOUNT INSULATOR AND
ENGINE REAR MOUNT BRACKET
Install the engine rear mount bracket with the 3 bolts.
Torque: 64 N·m (650 kgf·cm, 47 ft·lbf)
Install the engine rear mount insulator with the through
bolt.
Torque: 87 N·m (890 kgf·cm, 64 ft·lbf)
INSTALL PS GEAR ASSEMBLY
Align the matchmarks on the intermediate extension and
control valve shaft.
Install the bolt.
Torque: 35 N·m (360 kgf·cm, 26 ft·lbf)
Install the PS gear assembly with the 4 bolts to the front
suspension member.
Torque: 58 N·m (590 kgf·cm, 43 ft·lbf)
INSTALL FRONT SUSPENSION MEMBER WITH LOW-
ER SUSPENSION ARM AND PS GEAR ASSEMBLY
Torque:
Bolt C: 157 N·m (1,600 kgf·cm, 116 ft·lbf)
Bolt D: 157 N·m (1,600 kgf·cm, 116 ft·lbf)
Bolt E: 39 N·m (400 kgf·cm, 29 ft·lbf)
CONNECT ENGINE FRONT MOUNT INSULATOR AND
FRONT SUSPENSION MEMBER
Torque: 52 N·m (530 kgf·cm, 38 ft·lbf)
CONNECT ENGINE REAR MOUNT INSULATOR AND
FRONT SUSPENSION MEMBER
Torque: 52 N·m (530 kgf·cm, 38 ft·lbf)
CONNECT STABILIZER BAR
Connect the stabilizer bar with the nut.
Torque: 44 N·m (450 kgf·cm, 33 ft·lbf)
Employ the same manner described above to the other
side.
CONNECT LOWER BALL JOINT TO LOWER SUSPEN-
SION ARM (See page SA−46)
2098
SR−53
SR0YW−04