Toyota Celica 2005 Repair Manual page 1741

15.8 ± 0.2 mm
0 − 0.3 mm
SST
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
D07347
SST
D00321
SST
D00322
SST
D00323
Case
Cover
D07348
− MANUAL TRANSAXLE ASSEMBLY
(b) Using a screwdriver, remove the oil seal.
(c) Using SST and a hammer, drive in a new oil seal.
SST 09950−60010 (09951−00360), 09950−70010
(09951−07150)
Drive in depth: 15.8 ± 0.2 mm (0.622 ± 0.008 in.)
(d) Coat the lip of the oil seal with MP grease.
(e) Using SST and a press, install a new input shaft front
bearing.
SST 09950−60010 (09951−00400), 09950−70010
(09951−07150)
Drive in depth: 0 − 0.3 mm (0 − 0.012 in.)
NOTICE:
Be sure to install a new bearing in the correct direction, as
shown in the illustration.
5. IF NECESSARY, REPLACE OUTPUT SHAFT FRONT
BEARING AND OUTPUT SHAFT COVER
(a) Remove the bolt and bearing lock plate.
(b) Using SST, pull out the output shaft front bearing.
SST 09308−00010
(c) Remove the output shaft cover.
(d) Install the output shaft cover.
NOTICE:
Install the output shaft cover projection into the case side
hollow.
1740
MX−23