Toyota Celica 2005 Repair Manual page 2162

SUPPLEMENTAL RESTRAINT SYSTEM
LH:
RH:
H11988
H11989
LH:
RH:
2005 CELICA (RM1131U)
− FRONT AIRBAG SENSOR
INSTALLATION
1. INSTALL FRONT AIRBAG SENSOR LH AND RH
(a) Install the front airbag sensors with the 4 bolts.
Torque: 20 N·m (205 kgf·cm, 15 ft·lbf)
(b) Connect the front airbag sensor connector.
NOTICE:
Connection of the connector is done after the sensor
S
assembly has been installed.
Make sure the sensor is installed with the specified
S
torque.
If the sensor has been dropped, or there are cracks,
S
dents or other defects in the case, brackets or con-
nector, replace the removed sensor with a new one.
The front sensor is equipped with an electrical con-
S
nection check mechanism. Be sure to lock this mech-
anism securely when connecting the connector. If the
connector is not securely locked, a malfunction code
will be detected by the diagnostic system.
H12013
HINT:
Install the front airbag sensor with the arrow on the sensor fac-
ing toward the front of the vehicle.
2. INSTALL HEAD LIGHT
Install head lights with the 4 bolts and 2 screws (See page
BE−22).
3. INSTALL AIR CLEANER CASE
Install the air cleaner case with the 2 bolts.
4. INSTALL AIR FILTER
5. INSTALL AIR CLEANER CAP
6. INSTALL AIR CLEANER HOSE
7. INSTALL UPPER FRONT FENDER APRON SEAL
Install the upper front fender apron seal with the 5 clips.
H11990
2161
RS−61
RS0KH−08