Toyota Celica 2005 Repair Manual page 1526

TOYOTA Hand−Held Tester
DLC3
2005 CELICA (RM1131U)
(f)
Retainer
S05382
Click Sound
B07695
(g)
B07693
(h)
D07259
SFI − SFI SYSTEM
Observe these precautions when connecting the fuel
tube connector (quick type).
(1) Do not reuse the retainer removed from the pipe.
(2) Must use hands without using tools when to remove
the retainer from the pipe.
(3) Check if there is any damage or foreign objects on
the connected part of the pipe.
(4) Match the axis of the connector with axis of the pipe,
and push in the connector until retainer makes a
"click" sound. In case that the connections is tight,
apply little amount of new engine oil on the tip of the
pipe.
(5) After having finished the connection, check if the
pipe and the connector are securely connected by
pulling them.
(6) Install the fuel pipe clamp.
(7) Check if there is any fuel leakage.
Observe these precautions when handling nylon tube.
(1) Pay attention not to turn the connected part of the
nylon tube and the quick connector with force when
connecting them.
(2) Pay attention not to kink the nylon tube.
(3) Do not remove the nylon tube.
(4) Must not close the piping with the nylon tube by
bending it.
Check that there are no fuel leaks after doing mainte-
nance anywhere on the fuel system.
(1) Connect the TOYOTA hand−held tester to the
DLC3.
(2) Turn the ignition switch ON and push TOYOTA
hand−held tester main switch ON.
(3) Select the active test mode on the TOYOTA hand−
held tester.
(4) Please refer to the TOYOTA hand−held tester oper-
ator's manual for further details.
(5) If you have no TOYOTA hand−held tester, connect
the positive (+) and negative (−) leads from the bat-
tery to the fuel pump connector.
(See page SF−6)
(6) Check that there are no leaks from any part of the
fuel system.
(7) Turn the ignition switch to LOCK.
(8) Disconnect the TOYOTA hand−held tester from the
DLC3.
1525
SF−5