Toyota Celica 2005 Repair Manual page 2200

2
5
6
Wire harness side
2
1
3
2005 CELICA (RM1131U)
BODY ELECTRICAL
INSPECTION
1
1.
NOTICE:
If a resister is not placed, switch may be damaged.
Measure the voltage between terminals 4 and 5.
4
V
If current value is not as specified, replace the switch.
I25691
2.
Connect the battery positive (+) lead to terminal 3 and the bat-
tery negative (−) lead to terminal 6, and check that the illumina-
tion light comes on.
3
If operation is not as specified, replace the switch.
I14194
3.
V
NOTICE:
If a resister is not placed, switch may be damaged.
Disconnect the connector and inspect the connector on the wire
harness as shown in the chart.
I25692
If current value is not as specified, replace the actuator.
− HEADLIGHT BEAM LEVEL CONTROL SYSTEM
INSPECT HEADLIGHT BEAM LEVEL CONTROL
SWITCH CURRENT
Switch position
0
1
2
3
4
5
INSPECT HEADLIGHT BEAM LEVEL CONTROL
SWITCH ILLUMINATION
INSPECT HEADLIGHT BEAM LEVEL CONTROL AC-
TUATOR OPERATION
Switch position
0
1
2
3
4
5
2199
BE−25
BE1EN−06
voltage
Approx. 10.8 V
Approx. 9.5 V
Approx. 8.2 V
Approx. 7.0 V
Approx. 5.7 V
Approx. 4.4 V
voltage
Approx. 10.8 V
Approx. 9.5 V
Approx. 8.2 V
Approx. 7.0 V
Approx. 5.7 V
Approx. 4.4 V