Toyota Celica 2005 Repair Manual page 1959

SA−52
Cut out
Paint Line
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
REMOVAL
1. REMOVE STABILIZER BAR LINKS
(a) Remove the 2 nuts and stabilizer bar link.
Torque: 44 N·m (449 kgf·cm, 32 ft·lbf)
HINT:
If the ball joint turns together with the nut, use a hexagon (5 mm)
wrench to hold the stud.
(b) Employ the same manner described above to the other
side.
F08622
2. REMOVE FRONT SUSPENSION MEMBER WITH LOW-
ER SUSPENSION ARM (See page SA−43)
3. REMOVE STABILIZER BAR
(a) Remove the 2 bolts, bracket and bushing.
Torque: 19 N·m (194 kgf·cm, 14 ft·lbf)
HINT:
At the time of installation, please refer to the following items.
Install the bushing so that the cutout will face to the rear.
S
Install the bushing to the outside of the paint line on the
S
stabilizer bar.
(b) Employ the same manner described above to the other
F08668
side.
(c) Remove the stabilizer bar.
1958
− FRONT STABILIZER BAR
SA10I−07