Toyota Celica 2005 Repair Manual page 1915

SA−8
A B
Front
A: Inside
B: Outside
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
(b)
(c)
HINT:
Try to adjust the toe−in to the center of the specified value.
F08611
(d)
(e)
(f)
HINT:
Make sure that the boots are not twisted.
F08612
7.
B A
Turn the steering wheel fully, and measure the turning angle.
Wheel turning angle:
195/60R15, P195/60R15 tire:
205/55R15, P205/55R15 tire:
SA0028
205/50R16 tire:
If the right and left inside wheel angles differ from the specified
value, check the right and left rack end lengths.
− FRONT WHEEL ALIGNMENT
Loosen the tie rod end lock nuts.
Turn the right and left rack ends by an equal amount to
adjust the toe−in.
Make sure that the lengths of the right and left rack ends
are the same.
Rack end length difference: 1.5 mm (0.059 in.) or less
Torque the tie rod end lock nuts.
Torque: 74 N·m (750 kgf·cm, 54 ft·lbf)
Place the boots on the seats and install the clips.
INSPECT WHEEL ANGLE
Inside wheel
Outside wheel: Reference
Inside wheel
Outside wheel: Reference
Inside wheel
Outside wheel: Reference
1914
38°41' ± 2° (38.68° ± 2°)
33°20' (33.33°)
38°46' ± 2° (38.77° ± 2°)
33°25' (33.42°)
38°38' ± 2° (38.63° ± 2°)
33°19' (33.32°)