Toyota Celica 2005 Repair Manual page 1456

EM−70
2005 CELICA (RM1131U)
ENGINE MECHANICAL −
12. 1ZZ−FE:
CONNECT ENGINE WIRE TO CYLINDER HEAD
(a) Connect the 2 clamps of engine wire to the intake man-
ifold.
(b) Connect the 2 ground cables.
(c) Connect the oil control valve for VVT connector.
(d) Connect the camshaft position sensor connector.
(e) Connect the ECT sensor connector.
A21006
13. 2ZZ−GE:
CONNECT ENGINE WIRE TO CYLINDER HEAD
(a) Install the intake manifold insulator No. 2.
(b) Connect the 2 ground cables.
(c) Connect the oil pressure switch connector.
(d) Connect the oil control valve for VVT connector.
(e) Connect the oil control valve for VVTL connector.
(f) Connect the camshaft position sensor connector.
(g) Connect the ECT sensor connector.
A10441
(h) Install the accelerator cable bracket with the 2 bolts.
14. INSTALL INJECTORS (See page SF−24)
15. INSTALL THROTTLE BODY
(See page SF−38 or SF−44)
16. INSTAL PCV HOSES
17. INSTALL SPARK PLUGS (See page IG−1)
18. INSTALL IGNITION COIL (See page IG−7)
19. 1ZZ−FE:
INSTALL EXHAUST MANIFOLD
(a) Install the lower heat insulator with the 4 bolts.
Torque: 12 N·m (123 kgf·cm, 9 ft·lbf)
(b) Install a new gasket and the exhaust manifold with the 5
nuts. Uniformly tighten the nuts in several passes.
Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)
(c) Install the upper heat insulator with the 4 bolts.
Torque: 18 N·m (184 kgf·cm, 13 ft·lbf)
A21004
(d) Install the exhaust manifold stay with the 3 bolts.
Torque: 49 N·m (500 kgf·cm, 37 ft·lbf)
A21005
1455
CYLINDER HEAD