Toyota Celica 2005 Repair Manual page 2358

BO−52
Primer G
2005 CELICA (RM1131U)
9.
(a)
(b)
NOTICE:
H00471
S
S
10.
(a)
HINT:
After cutting off the tip, use all adhesive within the time de-
scribed in the table below.
(b)
(c)
Adhesive
A
Dam
B
H00464
11.
(a)
HINT:
Check to see that the stoppers are attached to the body correct-
ly.
(b)
BO2821
BODY − WINDSHIELD
COAT CONTACT SURFACE OF GLASS WITH PRIMER
"G"
Using a brush or sponge, coat the edge of the glass and
the contact surface with Primer G as shown in the illustra-
tion.
When the primer is coated wrongly to the area other than
the specified, wipe it off with a clean shop rag before the
primer dries.
Allow 3 minutes or more to dry the primer coated sur-
face.
Do not keep any of the opened Primer G for later use.
APPLY ADHESIVE
Cut off the tip of the cartridge nozzle.
Part No. 08850−00801 or equivalent
Temperature
35°C (95°F)
20°C (68°F)
5°C (41°F)
Load the cartridge into the sealer gun.
Coat the glass with adhesive as shown in the illustration.
A: 12.5 mm (0.492 in.)
B: 8.0 mm (0.315 in.)
INSTALL WINDSHIELD GLASS AND MOULDING
Install the glass, aligning the reference marks using a suc-
tion rubber.
Lightly press the glass front surface for close contact.
2357
Tackfree time
15 minutes
100 minutes
8 hours