Toyota Celica 2005 Repair Manual page 2216

3
4
5
4
2 1
5 4
Automatic
Stop Position
1
2
1
2005 CELICA (RM1131U)
BODY ELECTRICAL
6.
Connect the battery positive (+) lead to terminal 3 and the bat-
tery negative (−) lead to terminal 4, then check that the motor
operates at high speed.
If operation is not as specified, replace the motor with a new
one.
I11673
7.
(a)
I11674
(b)
(c)
2°36' +5
−10
If operation is not as specified, replace the motor.
I11675
8.
Connect the battery positive (+) lead to terminal 1, and the bat-
tery negative (−) lead to terminal 2 and the motor body, then
check that the motor operates intermittently for 9 − 15 seconds.
If operation is not as specified, replace the motor and relay with
2 new ones.
I11678
9.
Connect the battery positive (+) lead to terminal 2 and the bat-
tery negative (−) lead to terminal 1, then check that the motor
operates.
NOTICE:
These tests must be performed quickly (within 20 seconds)
to prevent the coil from burning out.
If operation is not as specified, replace the motor with a new
I01272
one.
− WIPER AND WASHER SYSTEM
High Speed:
INSPECT FRONT WIPER MOTOR OPERATION
Stopping at Stop Position:
INSPECT FRONT WIPER MOTOR OPERATION
Operate the motor at low speed and stop the motor opera-
tion anywhere except at the stop position by disconnect-
ing the positive (+) lead from terminal 5.
Connect terminal 1 and 5.
Connect the battery positive (+) lead to terminal 2 and bat-
tery negative (−) lead to terminal 4, then check that the
motor stops running at the stop position after the motor
operates again.
Intermittent:
INSPECT REAR WIPER MOTOR AND RELAY OPERA-
TION
w/o Rear wiper:
INSPECT WASHER MOTOR OPERATION
2215
BE−41