Toyota Celica 2005 Repair Manual page 2157

RS−56
SUPPLEMENTAL RESTRAINT SYSTEM
LH Side:
RH Side:
2005 CELICA (RM1131U)
− AIRBAG SENSOR ASSEMBLY
INSTALLATION
NOTICE:
Never use SRS parts from another vehicle. When re-
S
placing parts, replace them with new parts.
Never reuse the airbag sensor assembly involved in
S
a collision when the airbag has deployed.
Never repair a sensor in order to reuse it.
S
HINT:
For step 2 to 9, refer to page BO−85.
1. INSTALL AIRBAG SENSOR ASSEMBLY
(a) Using a torx® wrench, install the airbag sensor assembly
with the 3 screws.
Torx® wrench: T40 (Part No.09042−00020 or locally
manufactured tool)
Torque: 20 N·m (205 kgf·cm, 15 ft·lbf)
(b) Connect the airbag sensor connectors.
NOTICE:
Connection of the connector is done after the sensor
S
assembly has been installed.
Make sure the sensor assembly is installed with the
S
specified torque.
If the sensor assembly has been dropped, or there are
S
cracks, dents or other defects in the case, bracket or
connector, replace the sensor assembly with a new
one.
When installing the senor assembly, take care that
S
the SRS wiring does not interfere with other parts and
is not pinched between other parts.
H11986
After installing, shake the sensor assembly to check
S
that there is no looseness.
2. INSTALL END FINISH PANEL RH
3. INSTALL END FINISH PANEL LH
4. INSTALL CONSOLE BOX
5. INSTALL CONSOLE BOX HOLE COVER
6. INSTALL UPPER CONSOLE COVER
7. INSTALL FINISH PANEL
8. INSTALL LOWER NO. 1 PANEL
9. INSTALL LOWER FINISH PANEL
2156
RS0KC−13