Toyota Celica 2005 Repair Manual page 1680

ST−14
(3)
(4)
(2)
2005 CELICA (RM1131U)
STARTING
(c)
(d)
(1)
4.
B02284
(a)
(b)
5.
(a)
(b)
NOTICE:
Check that the positive (+) lead wires are not grounded.
6.
(a)
(b)
(c)
(d)
7.
B00229
− STARTER
Place these parts on the starter housing:
(1) New O−ring
(2) Starter clutch assembly
(3) Idler gear
(4) Bearing
Install the starter housing to the magnetic switch with the
2 screws.
Torque: 9.3 N·m (95 kgf·cm, 82 in.·lbf)
INSTALL FIELD FRAME
Install a new O−ring to the groove of the filed frame.
Align the protrusion of the field frame with the groove of
the magnetic switch, and install the field frame.
INSTALL BRUSH HOLDER
Place the brush holder on the field frame.
Using a screwdriver, hold the brush spring back, and con-
nect the brush into the brush holder. Connect the 4
brushes.
INSTALL END COVER
Install a new O−ring to the groove of the field frame.
Install the end cover to the field frame with the 2 screws.
Torque: 3.8 N·m (39 kgf·cm, 34 in.·lbf)
Install the field frame and armature assembly with the 2
through bolts.
Torque: 9.3 N·m (95 kgf·cm, 82 in.·lbf)
Connect the lead wire to terminal C with the nut.
Torque: 5.9 N·m (60 kgf·cm, 52 in.·lbf)
INSTALL NEW DUST PROTECTOR
1679