Toyota Celica 2005 Repair Manual page 2300

Tester Probe
Matching
Module
Repair Point
Masking Tape
2005 CELICA (RM1131U)
BODY ELECTRICAL
INSPECTION
1.
NOTICE:
S
S
NOTICE:
In order not to damage the glass printed antenna, wrap up
the tip of the tester stick with aluminum foil as shown in the
illustration and check by holding the aluminum foil with a
finger.
Aluminum Foil
BE4029
By placing and moving the tester stick along the glass printed
antenna, check if continuity exists.
I00430
HINT:
Matching module is built in the bus bar of the glass printed an-
tenna (main terminal side) of CELICA and no continuity exists
between the terminal and the antenna. Therefore, for the conti-
nuity checking of the glass printed antenna on the main anten-
na side of CELICA, place one probe of the tester on the position
beside the bus bar (position shown in the illustration) and check
by moving the other probe of the tester along.
I00459
2.
(a)
(b)
Broken
(c)
Wire
BE0150
− ANTENNA
GLASS PRINTED ANTENNA INSPECTION PROCE-
DURE
When cleaning the glass, use soft dry cloth, and wipe
the glass between the wire.
Take care not to damage the wires.
Do not use detergents or glass cleaners with abrasive
ingredients.
GLASS PRINTED ANTENNA REPAIR PROCEDURE
Clean the broken wire tips with grease, wax and silicone
remover.
Place the masking tape along both sides of the wire for
repair.
Thoroughly mix the repair agent (Dupont paste No.
4817).
2299
BE−125
BE0B0−12