Toyota Celica 2005 Repair Manual page 1777

MX−4
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
REMOVAL
1.
HINT:
At the time of installation, please refer to the following item.
Adjust the hood. (See page BO−9)
2.
Remove the 4 bolts and No. 2 cylinder head cover.
3.
Remove the bolt and disconnect the radiator reservoir.
4.
5.
(a)
(b)
(c)
(d)
(e)
(f)
6.
(a)
(b)
7.
Remove the 2 set bolts of the 2 ground cables from the trans-
axle.
8.
D07379
− MANUAL TRANSAXLE UNIT
REMOVE HOOD
REMOVE NO. 2 CYLINDER HEAD COVER
Torque: 7.0 N·m (71 kgf·cm, 62 in.·lbf)
DISCONNECT RADIATOR RESERVOIR
Torque: 4.9 N·m (50 kgf·cm, 43 in.·lbf)
REMOVE BATTERY
REMOVE AIR CLEANER CASE ASSEMBLY WITH AIR
HOSE AND ECM BOX
Remove the 2 bolts and ECM cover.
Torque: 6.9 N·m (70 kgf·cm, 61 in.·lbf)
Disconnect the ECM connectors from the ECM.
Remove the ECM outlet duct.
Remove the air cleaner case assembly with the air hose.
Remove the 3 bolts and ECM box.
Torque: 6.9 N·m (70 kgf·cm, 61 in.·lbf)
Disconnect the wire harness, and remove the 2 nuts, bolt
and battery carrier.
Torque:
Bolt: 18 N·m (185 kgf·cm, 13 ft·lbf)
Nut: 12 N·m (120 kgf·cm, 9 ft·lbf)
DISCONNECT CONTROL CABLE
Remove the 2 clips and washers.
Remove the 2 clips and disconnect the control cables
from the transaxle.
DISCONNECT GROUND CABLE
DISCONNECT SPEED SENSOR AND BACK−UP
LIGHT SWITCH CONNECTORS
1776
MX09Y−03