Toyota Celica 2005 Repair Manual page 2356

BO−50
Adhesive
7.0 mm (0.276 in.)
A
Stopper
2005 CELICA (RM1131U)
BODY − WINDSHIELD
INSTALLATION
1. CLEAN AND SHAPE CONTACT SURFACE OF BODY
(a) Using a knife, cut away any rough areas on the body.
HINT:
Leave the adhesive on the body as much as possible.
(b) Clean the cut surface of the adhesive with a shop rag sat-
urated in cleaner.
HINT:
Even if all the adhesive has been removed, clean the body.
BO4420
2. CLEAN REMOVED GLASS
(a) Remove the damaged No.2 stoppers and dams.
(b) Using a scraper, remove the adhesive sticking to the
glass.
(c) Clean the glass with cleaner.
NOTICE:
Be careful not to damage the glass.
S
Do not touch the glass face after cleaning it.
S
BO5231
3. w/ No. 1 Stopper:
REPLACE NO. 1 STOPPERS
(a) Remove the damaged stoppers.
(b) Cut off the old adhesive around the stopper installation
area.
NOTICE:
Be careful not to damage the body.
(c) Clean the installation area.
(d) Attach new stoppers to the body so that the notches on
H12587
the body will align with the stoppers as shown in the il-
lustration.
HINT:
Make sure that the stoppers are installed facing the correct
direction.
4. INSTALL NEW NO. 2 STOPPERS
Attach new stoppers to the glass so that the ceramic notches
on the glass will align with the stoppers as shown in the illustra-
tion.
HINT:
Make sure that the stoppers are installed facing the correct
direction.
A:
w/ No. 1 stopper: 7.7 ± 0.5 (0.303 ± 0.020 in.)
H12588
w/o No. 1 stopper: 9.0 ± 0.5 (0.354 ± 0.020 in.)
2355
BO2NS−02