Toyota Celica 2005 Repair Manual page 1535

SF−14
Tube Joint Clip
2005 CELICA (RM1131U)
SFI − FUEL PUMP
INSTALLATION
1. INSTALL FUEL PUMP ASSEMBLY
(a) Install the new gasket to the fuel pump assembly.
(b) Install the fuel pump assembly to the fuel tank.
NOTICE:
Do not damage the fuel pump filter.
S
Be careful that the arm of the sender gauge should
S
not bent.
(c) Install the 8 bolts and fuel tank vent tube set plate from the
B07702
fuel tank.
Torque: 4.0 N·m (40 kgf·cm, 35 in.·lbf)
2. CONNECT FUEL TUBE
(a) Clean up around the fuel tube.
(b) Connect the fuel tube and emission tube to the fuel pump
assembly.
(c) Connect the tube joint clip to the fuel suction plate.
3. CONNECT FUEL PUMP AND SENDER GAUGE CON-
NECTOR AND VAPOR PRESSURE SENSOR CON-
NECTOR
HINT:
B07700
Start the engine, check for fuel leakage.
4. INSTALL FLOOR SERVICE HOLE COVER
(a) Install the service hole cover.
(b) Install the floor carpet.
5. INSTALL REAR SEAT CUSHION
1534
SF09D−13