Toyota Celica 2005 Repair Manual page 1921

SA−14
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
5. LOOSEN 2 NUTS ON LOWER SIDE OF SHOCK AB-
SORBER
Torque: 153 N·m (1,560 kgf·cm, 113 ft·lbf)
HINT:
Do not remove the 2 bolts and nuts.
6. DISCONNECT TIE ROD END FROM STEERING
KNUCKLE
(a) Remove the cotter pin and nut.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
F08619
HINT:
At the time of installation, if the holes for a new cotter pin are not
aligned, tighten the nut further up to 60°.
(b) Using SST, disconnect the tie rod end from the steering
knuckle.
SST
SST
F08618
7. DISCONNECT LOWER SUSPENSION ARM FROM
LOWER BALL JOINT
Remove the 2 nuts and bolt.
Torque: 142 N·m (1,450 kgf·cm, 105 ft·lbf)
8. REMOVE STEERING KNUCKLE WITH AXLE HUB
(a) Remove the 2 bolts and nuts on the lower side of the
shock absorber.
HINT:
At the time of installation, coat the nut's thread with engine oil.
F02207
(b) Remove the steering knuckle with the axle hub.
NOTICE:
Be careful not to damage the boot and ABS speed sensor
rotor.
1920
− FRONT AXLE HUB
09610−20012