Toyota Celica 2005 Repair Manual page 1795

MX−22
Align Alignment Mark
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
29.
Remove the 2 bolts and oil receiver pipes from the transmission
case.
NOTICE:
At the time of reassembly, please refer to the following
items.
S
S
D07351
30.
Remove the 2 bolts and reverse shift arm bracket.
D07334
NOTICE:
At the time of reassembly, please refer to the following
items.
S
S
D07335
31.
NOTICE:
At the time of reassembly, please refer to the following
item.
Install the reverse idler gear, thrust washer and shaft, as
shown in the illustration.
D07336
32.
Using 2 screwdrivers and a hammer, tap out the 2 snap rings
from the No. 1 and No. 3 gear shift fork shafts.
D07338
− MANUAL TRANSAXLE ASSEMBLY
REMOVE OIL RECEIVER PIPE
Torque: 17 N·m (175 kgf·cm, 13 ft·lbf)
Prevent the oil receiver pipes from being deformed.
Install the oil receiver pipes while placing it against
the transmission case, as shown in the illustration.
REMOVE REVERSE SHIFT ARM BRACKET
Torque: 17 N·m (175 kgf·cm, 13 ft·lbf)
Set the pin on the top of the reverse shift arm into a
groove on the reverse idler gear.
Fit the claw of the reverse shift arm bracket with the
notch of the input shaft front bearing.
REMOVE REVERSE IDLER GEAR, THRUST WASHER
AND SHAFT
REMOVE GEAR SHIFT FORK SHAFT SNAP RING
1794