Toyota Celica 2005 Repair Manual page 1963

SA−56
Backlash:
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
REMOVAL
1.
2.
(a)
(b)
3.
F08644
4.
Deviation:
(a)
If the backlash exceeds the maximum, replace the axle hub.
(b)
F08641
If the deviation exceeds the maximum, replace the axle hub.
5.
6.
(a)
(b)
7.
Remove the nut and disconnect stabilizer bar link.
HINT:
If the ball joint turns together with the nut, use a hexagon (5 mm)
F08645
wrench to hold the stud.
− REAR AXLE CARRIER
REMOVE REAR WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
w/ Disc brake:
REMOVE BRAKE CALIPER AND DISC
Remove the 2 bolts, brake caliper and disc.
Torque: 47 N·m (475 kgf·cm, 34 ft·lbf)
Support the brake caliper securely.
w/ Drum brake:
REMOVE BRAKE DRUM
CHECK BEARING BACKLASH AND AXLE HUB DEVI-
ATION
Using a dial indicator, check the backlash near the center
of the axle hub.
Maximum: 0.05 mm (0.0020 in.)
Using a dial indicator, check the deviation at the surface
of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 in.)
w/ ABS:
DISCONNECT ABS SPEED SENSOR CONNECTOR
REMOVE REAR AXLE HUB
Remove the 4 bolts and axle hub assembly.
Torque: 56 N·m (571 kgf·cm, 41 ft·lbf)
Support the backing plate securely.
DISCONNECT STABILIZER BAR LINK
Torque: 44 N·m (449 kgf·cm, 32 ft·lbf)
1962
SA1P8−02