Toyota Celica 2005 Repair Manual page 2403

Wire Harness Protector
2005 CELICA (RM1131U)
BODY − FRONT SEAT
REASSEMBLY
1. ASSEMBLE OUTER TRACK AND INNER TRACK
Assemble the outer track and inner track with a new E−ring.
2. INSTALL SEAT TRACK HANDLE
3. INSTALL RECLINING CONNECTING PIPE
(a) Adjust the reclining lock positions of the seat adjusters.
(b) Slide the seat adjusters to the most front position.
(c) Place the adjusters on a spacer to adjust the seat rail in
parallel and install the connecting pipe.
HINT:
When installing the connecting pipe while raising up the adjust-
ers, the lock position adjusted in 3−(a) may become detached.
When this happens, a lock error will occur.
H12640
4. INSTALL SEAT CUSHION ASSEMBLY
(a) Install the seat cushion cover to the seat cushion pad with
new hog rings.
HINT:
When installing the hog rings, take care to prevent wrinkles as
much as possible.
(b) Install the seat cushion frame to the seat cushion cover
with pad.
(c) Engage the seat cushion hooks and install new hog rings.
HINT:
When installing the hog rings, take care to prevent wrinkles as
much as possible.
(d) Install the seat cushion assembly with the 4 bolts.
Torque: 21 N·m (210 kgf·cm, 15 ft·lbf)
5. INSTALL FRONT SEAT INNER BELT
(a) Pass the wire harness of front seat inner belt through the
wire harness protector of seat cushion assembly and
install the front seat inner belt.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
(b) Install the front seat inner belt wire harness to the seat
cushion frame.
H12641
2402
BO−97
BO2OD−02