Toyota Celica 2005 Repair Manual page 2011

BR−24
2005 CELICA (RM1131U)
BRAKE − FRONT BRAKE CALIPER
DISASSEMBLY
1. REMOVE SET RING AND CYLINDER BOOT
Using a screwdriver, remove the set ring and cylinder boot from
the caliper.
R09298
2. REMOVE PISTON
(a) Place a piece of cloth or similar, between the piston and
the caliper.
(b) Use compressed air to remove the piston from the cylin-
der.
CAUTION:
Do not place your fingers in front of the piston when using
compressed air.
3. REMOVE PISTON SEAL
Z17243
Using a screwdriver, remove the piston seal from the cylinder.
4. REMOVE BLEEDER PLUG CAP AND BLEEDER PLUG
5. REMOVE SLIDING PINS AND DUST BOOTS
(a) Remove the 2 sliding pins from the torque plate.
(b) Using a screwdriver and hammer, tap out the 2 dust
boots.
HINT:
At the time of reassembly, use a 19 mm socket wrench and tap
in 2 new dust boots into the torque plate.
NOTICE:
At the time of reassembly, check that the metal plate por-
tion of the dust boot fits snugly in the torque plate.
R02877
2010
BR0QF−05