Toyota Celica 2005 Repair Manual page 2085

No. 1 Engine Hanger
E
C
D
Nut
2005 CELICA (RM1131U)
STEERING
11.
No. 2 Engine
Hanger
(a)
(b)
(c)
A10434
(d)
CAUTION:
Do not attempt to hang the engine by hooking the chain to
any other part.
12.
13.
(a)
(b)
14.
Remove the bolt (bolt A) and 3 nuts, and disconnect the engine
rear mount insulator and front suspension member.
15.
B
Remove the 2 bolts (bolt B) and disconnect the engine front
mount insulator and front suspension member.
16.
A
Using a transmission jack, support the front suspension mem-
ber with lower suspension arm.
17.
C
Remove the 6 bolts (bolt C, D and E) and front suspension
member with lower suspension arm and PS gear assembly.
D
18.
(a)
F08864
− POWER STEERING GEAR
ATTACH ENGINE SLING DEVICE TO ENGINE HANG-
ERS
Remove the 4 bolts and No. 2 cylinder head cover.
Disconnect the PCV hoses from the cylinder head cover.
Install the No. 1 and No. 2 engine hangers in the correct
direction.
1ZZ−FE Engine:
Part No.:
No. 1 engine hanger: 12281−22021
No. 2 engine hanger: 12281−15040 or 12281−15050
Bolt: 91512−B1016
Torque: 38 N·m (388 kgf·cm, 28 ft·lbf)
2ZZ−FE Engine:
Part No.:
No. 1 engine hanger: 12281−88600
No. 2 engine hanger: 12282−88600
Bolt: 91512−61020
Torque: 38 N·m (388 kgf·cm, 28 ft·lbf)
Attach the engine sling device to the engine hangers.
DISCONNECT LOWER BALL JOINT FROM LOWER
SUSPENSION ARM (See page SA−43)
DISCONNECT STABILIZER BAR
Remove the nut and disconnect the stabilizer bar.
Employ the same manner described above to the other
side.
DISCONNECT ENGINE REAR MOUNT INSULATOR
AND FRONT SUSPENSION MEMBER
DISCONNECT ENGINE FRONT MOUNT INSULATOR
AND FRONT SUSPENSION MEMBER
SUPPORT FRONT SUSPENSION MEMBER WITH
LOWER SUSPENSION ARM
REMOVE FRONT SUSPENSION MEMBER WITH LOW-
ER SUSPENSION ARM AND PS GEAR ASSEMBLY
REMOVE PS GEAR ASSEMBLY
Remove the 4 bolts and PS gear assembly from the front
suspension member.
2084
SR−39