Toyota Celica 2005 Repair Manual page 2038

Release Bar
SST
2005 CELICA (RM1131U)
BRAKE − ABS ACTUATOR
REMOVAL
1. REMOVE BATTERY
Remove the hold−down clamp, battery and battery tray.
2. REMOVE MASTER CYLINDER (See page BR−11)
3. REMOVE ECM AND ECM BRACKET
(a) Remove the engine room duct.
(b) Remove the 3 bolts, and move the ECM aside.
(c) Disconnect the 2 harness clamps, and remove the bolt,
2 nuts and ECM bracket.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
F09694
4. DISCONNECT ABS ACTUATOR CONNECTOR
Pull the release bar and disconnect the ABS actuator connec-
tor.
F16319
5. DISCONNECT BRAKE LINES
Using SST, disconnect the 6 brake lines.
SST 09023−00101
Torque: 15 N·m (155 kgf·cm, 11 ft·lbf)
HINT:
When disconnecting the brake lines, Use tags or make a
S
memo to identify the place to reconnect (See page
BR−50).
At the time of installation, connect each brake line to the
S
F17100
correct position (See page BR−50).
6. REMOVE ABS ACTUATOR
(a) Remove the bolt, nut and ABS actuator assembly.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
(b) Remove the 2 nuts and ABS actuator from the actuator
bracket.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
F17099
2037
BR−51
BR1U2−03