Toyota Celica 2005 Repair Manual page 1974

SST
Front
LH
42. 6° ± 2°
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
REASSEMBLY
1.
(a)
NOTICE:
Do not use an impact wrench. It will damage the SST.
(b)
HINT:
F02221
Fit the lower end of the coil spring into the gap of the spring low-
er seat.
2.
3.
(a)
(b)
RH
(c)
(d)
(e)
(f)
42. 6° ± 2°
F08649
(g)
F08632
− REAR SHOCK ABSORBER
INSTALL COIL SPRING
Using SST, compress the coil spring.
SST 09727−30021 (09727−00010, 09727−00021,
09727−00031)
Insert the coil spring to the shock absorber.
INSTALL SPRING BUMPER AND SUSPENSION SUP-
PORT
INSTALL SPRING BRACKET
Set the upper insulator to the spring bracket.
Position the spring bracket with upper insulator as shown
in the illustration.
Install the cushion and washer.
Temporarily tighten the center nut.
Remove the SST.
SST 09727−30021 (09727−00010, 09727−00021,
09727−00031)
Recheck the direction of the spring bracket.
Using a 6 mm hexagon wrench to hold the piston rod,
tighten the nut.
Torque: 56 N·m (571 kgf·cm, 41 ft·lbf)
1973
SA−67
SA1OX−03