Toyota Celica 2005 Repair Manual page 1950

2005 CELICA (RM1131U)
SUSPENSION AND AXLE
REMOVAL
1. REMOVE FRONT WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
2. M/T or A/T RH side:
REMOVE LOWER SUSPENSION ARM
(a) Remove the engine under cover.
(b) Remove the bolt and 2 nuts, and disconnect the lower
suspension arm from the lower ball joint.
Torque: 142 N·m (1,450 kgf·cm, 105 ft·lbf)
F02253
(c) Remove the 2 bolts, nut and lower suspension arm.
Torque: 137 N·m (1,397 kgf·cm, 101 ft·lbf)
HINT:
At the time of installation, after stabilizing the suspension,
torque the bolts.
3. A/T LH side:
REMOVE LOWER SUSPENSION ARM
(a) Remove the engine under covers.
(b) Disconnect the RH and LH tie rod ends.
F08646
(1)
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
HINT:
At the time of installation, if the holes for a new cotter pin are not
aligned, tighten the nut further up to 60°.
(2)
SST
(3)
SST
F08664
− FRONT LOWER SUSPENSION ARM
Remove the cotter pin and nut.
Using SST, disconnect the tie rod end from the
steering knuckle.
09610−20012
Employ the same manner described above to the
other side.
1949
SA−43
SA1OS−03