Toyota Celica 2005 Repair Manual page 2016

SST
SST
2005 CELICA (RM1131U)
BRAKE − REAR DRUM BRAKE
REMOVAL
1. INSPECT SHOE LINING THICKNESS
Remove the inspection hole plug, and check the shoe lining
thickness through the hole.
If less than minimum, replace the shoes.
Minimum thickness: 1.0 mm (0.039 in.)
2. REMOVE REAR WHEEL
F09777
3. REMOVE BRAKE DRUM
(a) Release the parking brake lever, and remove the brake
drum.
HINT:
If the brake drum cannot be removed easily, do the following
steps.
(b) Remove the plug and insert a screwdriver through the
hole in the backing plate.
(c) Using another screwdriver, reduce the brake shoe adjust-
F07782
er by turning the adjusting wheel.
4. REMOVE FRONT SHOE
(a) Using SST, disconnect the adjuster spring from the rear
shoe.
SST 09703−30010
(b) Using needle−nose pliers, remove the anchor spring.
F09776
(c) Using SST, remove the cap, shoe hold−down spring and
pin from the front shoe.
SST 09718−00010
(d) Remove the adjuster and adjuster spring together with
the front shoe.
(e) Remove the adjuster together with the adjuster spring
from the front shoe.
(f) Using needle−nose pliers, remove the adjusting lever
spring.
F09778
(g) Remove the automatic adjusting lever from the front
shoe.
5. REMOVE REAR SHOE
(a) Using SST, remove the cap, shoe hole−down spring and
pin.
SST 09718−00010
2015
BR−29
BR14B−03