Toyota Celica 2005 Repair Manual page 1735

SST
SST
SST
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
15.
(a)
HINT:
At the time of reassembly, please refer to the following item.
Select a snap ring from the table below that will make the thrust
clearance of the No. 3 clutch hub less than 0.1 mm (0.0039 in.).
Mark
Z00659
A
B
C
D
(b)
(c)
HINT:
Select a bolt whose outer diameter is smaller than the screw
hole of the input shaft so that it can be turned easily.
(d)
D04554
16.
Using SST, remove the 5th driven gear.
SST
Q07893
HINT:
At the time of reassembly, please refer to the following item.
Using SST, install the 5th driven gear.
N00174
− MANUAL TRANSAXLE ASSEMBLY
REMOVE NO. 3 CLUTCH HUB AND 5TH GEAR
Using 2 screwdrivers and a hammer, tap out the snap
ring.
Thickness mm (in.)
2.25 (0.0886)
2.31 (0.0909)
2.37 (0.0933)
2.43 (0.0957)
Using a screwdriver, remove the shifting key spring from
the No. 3 clutch hub.
Install a bolt and washer to the tip of the input shaft and
using SST, remove the No. 3 clutch hub.
SST 09950−30012
Remove the No. 3 synchronizer ring, 5th gear, needle roll-
er bearing and spacer.
REMOVE 5TH DRIVEN GEAR
SST 09628−62011, 09950−40011 (09957−04010),
09950−60010 (09951−00230)
SST 09309−12020
1734
Mark Thickness mm (in.)
E 2.49 (0.0980)
F 2.55 (0.1004)
G 2.61 (0.1028)
− −
MX−17