Toyota Celica 2005 Repair Manual page 2080

SR−34
SST
Fulcrum Length
Drive Belt
Tensioner Arm
2005 CELICA (RM1131U)
STEERING − POWER STEERING VANE PUMP
INSTALLATION
1. INSTALL PS VANE PUMP ASSEMBLY
Install the PS vane pump assembly with the 2 pump assembly
set bolts and nuts.
Torque: 37 N·m (370 kgf·cm, 27 ft·lbf)
2. CONNECT OIL PRESSURE SWITCH CONNECTOR
NOTICE:
Be careful to prevent oil from being attached to the connec-
tor.
3. CONNECT PRESSURE FEED TUBE
(a) Connect the pressure feed tube clamp with the bolt.
Torque: 7.8 N·m (80 kgf·cm, 69 in.·lbf)
(b) Using SST, connect the pressure feed tube.
SST 09023−38401
Torque: 40 N·m (410 kgf·cm, 30 ft·lbf)
HINT:
Use a torque wrench with a fulcrum length of 345 mm
S
(11.81 in).
F13579
This torque value is effective in case that SST is parallel
S
to a torque wrench.
4. CONNECT SUCTION HOSE
Connect the suction hose with the clip.
5. INSTALL DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner
arm clockwise, and install the drive belt.
6. INSTALL RH AND CENTER ENGINE UNDER COVERS
7. BLEED POWER STEERING SYSTEM
(See page SR−4)
F08868
2079
SR0YQ−05